Product License Unlocking - NEC Storage Manager User Manual

Chapter 1 Installation Procedure
Director No.
00
01
00
01
Table 1-6 gives an Access Control setting example for an LD configuration example when a control
volume is used (Figure 1-4).
Table 1-6 Access Control Setting Example (When a Control Volume is Used)
Director No.
00
01
00
01
When setting the configuration, take care not to overlap the ports (MV side) connected to the business
servers and those (RV side) connected to the evaluation and backup servers.
1 . 4 . 4
1 . 4 . 4
1 . 4 . 4
To use the DynamicDataReplication or the RemoteDataReplication, you must unlock the product
license set in the disk array. To unlock the license, you must purchase the corresponding products for
the capacity category equal to or greater than the total physical capacity of the disk array.
When the replication management is executed by starting up the ReplicationControl, these products
check the licenses of the products purchased whether they are purchased properly.
If the total capacity of the physical disk exceeds the product's specified capacity because physical disks
are added to the disk array system, no additional pairs can be set or canceled (however, replication
operations for the preset pairs are enabled).
Table 1-5 Access Control Setting Example
Port No.
00
00
01
01
Port No.
00
00
01
01
P r o d u c t L i c
P r o d u
c t L i c
P r o d u c t L i c
Access Control settings
LD00 to LD04
LD05 to LD09
Access Control settings
LD00 to LD04
LD05 to LD09 and
LD0a
e n s e U n l o c k
e n s e U n l o c
e n s e U n l o c
14
Server connected
Business server
Backup server
Server connected
Business server
Backup server
i n g
k i n g
k i n g