Table of Contents
Advertisement
Switch. This interface allows you to access the switch using the Web browser
of your choice.
2.8.1.
Logging on the switch
To log on to the Switch:
1. In your web browser, specify the IP address of NP2724M. Default IP
address is 192.168.1.254.
2. Enter the factory default user name: "admin" and no password to login to
the web management interface of the switch.
2.9. Command Line Interface (by Console or Telnet)
2.9.1.
Mode-based Command Hierarchy
The Command Line Interface (CLI) groups all the commands in appropriate
modes by the nature of the commands. Examples of the CLI command modes
are described below. Each of the command modes supports specific switch's
commands.
The CLI Command Modes table captures the command modes, the prompts
visible in that mode and the exit method from that mode.
Table 1 CLI Command Modes
Command
Access Method
Mode
This is the first
level of access.
Perform basic
User Mode
tasks and list
system
information.
From the User
Privileged
Mode, enter the
Mode
enable command.
From the
Global
Privileged Mode,
enter the
Config
Mode
configuration
command.
From the Global
Interface
Config mode, enter
Config
the interface
Mode
<port#> command.
The CLI is divided into various modes. The commands in one mode are not
available until the operator switches to that particular mode. The commands
available to the operator at any point in time depend upon the mode. Entering
a question mark (?) at the CLI prompt, and displays a list of the available
commands and descriptions of the commands.
The CLI provides the following modes:
NP2724M User Manual
Prompt
COMMAND>
Switch#
Switch (Config)#
Switch (Interface <port#>)#
Exit or Access
Previous Mode
Enter Logout
command
To exit to the User
Mode, enter exit or
Logout.
To exit to the
Privileged Mode,
enter the exit
command.
To exit to the Global
Config mode, enter
exit.
10
Advertisement
Table of Contents
