Selecting The Host Communication Method - Omron NT-series Operation Manual

4-6-1

Selecting the Host Communication Method

RS-232C method
[ MEMORY SWITCH MENU (2/2) ]
Automatic Reset
Data Bit Length
Stop Bit Length
Parity Bit
FlowControl
RS-232C Speed
Automatic Reset Selecting the Automatic Reset Function (page 90)
Host Link Speed Selecting the Host Link Communication Speed (page 86)
PT UNIT No. Setting the PT UNIT No. (page 87)
Data Bit Length Setting the RS-232C Communication Conditions (page 89)
Stop Bit Length Setting the RS-232C Communication Conditions (page 89)
Parity Bit Setting the RS-232C Communication Conditions (page 89)
Flow Control Setting the RS-232C Communication Conditions (page 89)
RS-232C Speed Setting the RS-232C Communication Conditions (page 89)
The NT600S can be connected to a PC/Host by the host link, NT link (1:1, 1:N),
C200H direct, or RS-232C. Either link can be selected by setting the "Comm.
Method" memory switch. The factory setting has been made to the "Host link".
Select the host communication method by the menu operation from the System
Menu as mentioned below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting Status
I/O Check
Memory Init.
Memory Switches
EXIT
ON
7bits
PREV.
2bits
PAGE
Odd
SAVE
XON/XOFF
EXIT
19200bps
Select "Maintenance Mode".
Select "Memory Switches".
Display History
Section 3-6