Omron NT-series Operation Manual page 290

Connector Cover Assembly
Assemble the connector covers as shown in the diagram below.
Preparing RS-232C Connector Cables
Prepare a connector cable to connect a NT600S to a HOST separated by more than 5 m so that the supplied con-
nector cable (XW2Z-500P) cannot be used. The maximum cable length is 15 m.
Recommended Parts
Name
Connector XM2A-0901
Connector cover XM2S-0911
Cable AWG28
IFVV-SB


CO-MA-VV-SB
5P
On the other end of the cable use the type of connector and connector cover which matches the host computer
connector type.
Connection For Host
NT600S
RS-232C
interface
Note
End connected to FG
Model
9-pin, manufactured by OMRON
9-pin, manufactured by OMRON


5P Multicore cable, manufactured by Fujikura, Ltd.
Multicore cable, manufactured by Hitachi Cable, Ltd.
28AWG
Only the shielded wire on the host side is connected to the connector hood. The
following diagram is for RS/CS control. If RS/CS control is not executed, RS and
CS must be short-circuited (turned over) for both the NT600S and host side.
Abbrevi- Pin
ation number
FG 1
SD 2
RD 3
RS 4
CS 5
+5V 6
-- 7
-- 8
SG 9
For some host computers the combination of pin numbers and signal names may
differ from those shown in the diagram above. Refer to the Host instruction manu-
al before wiring the connector.
Aluminum foil tape
End not connected to FG
Remarks
HOST
Pin
number
1
2
3
4
5
6
7
8
Shielding
wire
Appendix E
Abbrevi-
ation
--
RD
SD
RS-232C
--
interface
SG
--
RS
CS