Selecting The Host Communication Method - Omron NT11S Operation Manual

Setting the Conditions of Communications with the PC by Using the Memory Switches
3-7-1

Selecting the Host Communication Method

Reference
58
The NT11S can be connected to a PC by the host link or NT link. Either link can be
selected by setting the "Comm. Type" memory switch. The factory setting has
been made to the "Host link".
Select the host communication method by the menu operation from the System
Menu as mentioned below.
SYSTEM MENU
Quit
Transmit Mode
Maintenance Mode
PT Setting
I/O Check
Initialize Memory
Memory Switch
Backlight OFF
Auto-restart
Page:
Comm. Type
Baud Rate
Comm. Port RS-232C
To quit after setting the selection made, press the "ENTER" key. To quit without
setting the selection made, press any two function keys simultaneously.
The communication method must be selected according to the method that the
connecting PC supports.
Page:
10min
Yes
Host Link
9600BPS
Section 3-7
Select "Maintenance
with the key, then press "EN-
TER".
Select "Memory Switch" with the
key, then press "ENTER".
Display the next screen by
pressing the key.
Pressing the [+/--] key while
"Comm. Type" is highlighted will
cause the selection for this item
to alternate between "Host Link"
and "NT Link".
Mode"