Omron NT-series Operation Manual page 200

' 4  -  4     
Reference
Procedure 1. Use the support tool to allocate the touch switch notify bits to the PC memory.
The status of the notify bit reflects the touch switch status, as follows:
Momentary : 0 (OFF) ... Not pressed
1 (ON) ... Pressed
Alternate : The bit allocated for notification is set to 1 (ON) if currently 0, and to
0 (OFF) if currently 1.
Set : The bit allocated for notification is forcibly set to 1 (ON).
Reset : The bit allocated for notification is forcibly set to 0 (OFF).
The status of a touch switch is determined by checking the ON/OFF status of its
notify bit.
The touch switch notify bits can be allocated to the following areas of the PC
memory.
Symbol C Series PCs
DM Data memory
CH Internal/Special Relay
TIM Timer
CNT Counter
HR Holding Relay
AR Auxiliary Relay
LR Link Relay
When making a data memory (DM) specification, specify the bit number (00 to 15)
following the word number.

It is not possible to allocate a momentary switch to the same word as an alter-
nate/set/reset switch.

Since all the CVM1/CV-series special auxiliary relays are allocated to the sys-
tem, they cannot be used for applications not related to the system.
The range of each memory area differs according to the PC type. See "Appendix L
PC Memory Map" (page 291) for more details.
2. When creating the screen data using the support tool, register the touch switch
for a screen.
3. Create the PC program to switch the notify bit of the touch switch ON and OFF.
Allocated CVM1/CV Series PCs
Data memory
Internal/Special Relay


Timer


Counter
--
Auxiliary Relay
--
Section 5-3
Allocated








: OK : NG