Table of Contents
Advertisement
"Hardware Options" submenu
Figure 16-7
The parameters of the interfaces present on the motherboard are set here.
Entry
PCI - MPI / DP
Onboard Ethernet 1/2
Ethernet 1/2 Address
Ethernet 1/2 Remote
Boot
Dual view DVI/CRT
Note
The second Ethernet interface support is OS dependent. For DOS based applications (e.g.
Image Creator), use the first Ethernet interface and disable the second Ethernet interface in
BIOS Setup. This is practical because some programs use the second Ethernet interface
because it is the first one found on the PCI bus.
SIMATIC IPC427C
Operating Instructions, 04/2009, A5E02414743-01
"Hardware Options" field
Meaning
Enabled
Disabled
Enabled
Disabled
Shows the individual Ethernet address.
Enabled
Disabled
Enabled
Disabled
Sharing the MPI/DP interface. The resources are managed
by the BIOS PCI Plug and Play mechanism.
The MPI/DP interface is disabled.
The Ethernet port on the motherboard is enabled.
The Ethernet port on the motherboard is disabled.
Booting via a connected LAN is possible.
Booting via LAN is not possible.
Dual view DVI/CRT is available via the DVI-I socket.
Only one monitor can be enabled via the DVI/VGA socket.
Detailed descriptions
16.2 BIOS Setup
121
Advertisement
Table of Contents
