ZyXEL Communications XOHM MAX-206M2 User Manual page 57

The antennas must be installed to provide a separation distance of at least 20cm from all persons to
satisfy FCC RF exposure compliance.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communication. There is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
Consult the dealer or an experienced radio or television technician for help
This device complies with Part 15 of the FCC's Rules. Operation is subject to the
following two conditions:
1.
This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesirable operation.
Any changes or modifications not expressly approved by XOHM could void the
Caution:
user's authority to use the equipment.
If you have purchased this product under a United States Government contract, it shall
be subject to restrictions as set forth in subparagraph (c)(1)(ii) of Defense Federal
Acquisitions Regulations (DFARs) Section 252.227-7013 for Department of Defense
contracts, and as set forth in Federal Acquisitions Regulations (FARs) Section 52.227-
19 for civilian agency contracts or any successor regulations. If further government
regulations apply, it is your responsibility to ensure compliance with such regulations.
Important User Information 49