ZyXEL Communications XOHM MAX-206M2 User Manual page 50

My XOHM Modem is not working properly (lights are coming on but I cannot connect).
What do I do?
Your modem may not be receiving the proper voltage. Make sure you are using
the power adapter that came with your modem. The correct adapter for the
MAX-206M2 provides output power of 12V AC at 1 Amp.
The
WiMAX Signal LED
If it is not illuminated, make sure the
at
XOHM Care
If neither of the
Make sure that your computer or router has the Ethernet cable connected to the
Ethernet port and that the cable is properly seated. (The cable should "click"
when it is connected.)
Make sure the other end of the Ethernet cable is properly connected to the
or
LAN 1 LAN 2
Ethernet cables usually have clips that help secure them to Ethernet ports. If
these clips are damaged or broken, the cable could slip out. If your Ethernet
cables or clips are damaged or broken, replace with a new cable.
If the cable is securely connected at both ends, but the corresponding
LED is still not illuminated, try using the other LAN port on the XOHM
LAN 2
Modem.
The computer may have a faulty Ethernet adapter.
The lights on my XOHM Modem are on, but they are all red. What do I do?
The LED indicators on the XOHM Modem should not be red if the modem is
functioning properly.
Red LEDs may indicate faulty configuration. Press and hold the red
the back of the device for 10–15 seconds and then release the button to restore the
factory default settings. The modem will power cycle (turn off and on) during the
reset process.
If the lights remain red after reset, call
42 Troubleshooting
should be illuminated if the modem is using default settings.
(9646).
877-333-XOHM
is illuminated:
LAN LEDs
port on the back of the XOHM Modem.
is green. If the
Power LED
at
XOHM Care 877-333-XOHM
is red, call
Power LED
or
LAN 1
on
Reset Button
(9646).