Download Print this page

Toshiba MJ-1101 Service Manual Addendum page 8

Supplement to the troubleshooting section

Advertisement

Error code
Phenomenon
Possible cause
EA70
- When more than one
1. Catching pad deformed or
EA60
sheet of paper is
damaged
CC30
loaded on the buffer
CC41
tray, the first sheet is
(Paper is not aligned properly due
pushed out of the tray
to the deformed or damaged
by the second sheet.
catching pad.)
- When more than one
sheet of paper is
loaded on the buffer
tray, the leading edge
of the second sheet is
caught and thus a
paper jam occurs.
- When paper is
2. Catching pad link arm
transported from the
deformed, damaged or removed
buffer tray to the
finishing tray, the
(Paper is not aligned properly
paper is run on the
because the link arm of the
front or rear alignment
catching pad is deformed,
plate.
damaged or removed.)
- When paper is
loaded on the finishing
tray, the front and rear
alignment plates
excessibly push the
paper.
- When paper is
transported from the
finishing tray to the
3. Improper roller gap on the
movable tray, the
buffer roller guide and buffer tray
paper exit guide
catches the paper and
thus a motor error
occurs because the
paper cannot exit.
Items to confirm / Countermeasures
Check if the catching pad in the Finisher paper exit section is properly attached. Replace it if it is deformed or
damaged.
Normal
Catching pad
Check if the catching pad in the Finisher paper exit section is properly attached. If its link arm is deformed,
damaged or removed, replace ARM-SOL-ALIGN (6LB100080).
Catching pad link arm
Turn the power OFF. Then check the gap between rollers on the buffer roller guide and the buffer tray while the
buffer roller is left lowered. If the gap does not reach 0.3 mm, replace the buffer roller guides (LVR-E-RLR-BUF)
on both front and rear sides.
Buffer roller guide
Buffer roller guide
Buffer roller
RLR-EXIT-BUFFER
Roller on the buffer tray
RLR-EXIT-TRY
Abnormal
Facing down
0.3 mm or
Within the range 7 mm
more
from the edge
Buffer roller guide
LVR-E-RLR-BUF
Buffer tray
Precautions / Remarks
Check the gap within the range 7 mm from the edge of the buffer roller guide.

Advertisement

loading