Original/Copy Paper-Related Items; Image Trouble - Toshiba e-STUDIO195 Operator's Manual

Original/Copy paper-related items

Phenomenon
An original jams.
Copy paper jams.
Multiple feeding occurs.

Image trouble

Phenomenon
The density of the copy
image is light.
The density of the copy
image is dark.
Usual cause
An original not acceptable for
the equipment is being used.
Copy paper not acceptable
for the equipment is being
used.
The size of the copy paper in
the drawer or on the bypass
tray is not registered prop-
erly in the equipment.
Jammed paper is located in
a place you cannot see eas-
ily.
There is no gap between the
side guides and paper in the
drawer. Or the gap is too
wide.
There is a gap between the
paper and the end guide in
the drawer.
Paper is clinging to each
other.
Usual cause
Toner has run out.
The copy density is set
lighter.
The transfer charger wire is
dirty.
The copy density is set
darker.
Before Calling Service Technician
Countermeasure
Check if the original is acceptable for the
equipment.
P.57 "Precautions for Reversing Auto-
matic Document Feeder (optional) / Auto-
matic Document Feeder (optional)"
Check if the copy paper is acceptable for
the equipment.
P.40 "Paper types not acceptable"
Register the size of the placed copy paper
properly.
P.49 "Preparation 3 - Registering Size
of Paper Placed"
P.64 "Bypass copying"
See the message on the display to
recheck the position where the paper jam
has occurred.
P.176 "Paper Jams"
Adjust the gap between the side guides
and the paper properly.
P.41 "Placing paper in drawers"
Do not allow any gap between the paper
and the end guide in the drawer.
P.41 "Placing paper in drawers"
Fan the paper well and place it again.
Countermeasure
"Toner empty" appears on the display
when toner has run out. Replace the toner
cartridge if the message appears.
P.190 "Replacing Toner Cartridge"
Make the density darker if you use the
manual copy density mode. Or use the
automatic copy density mode.
Clean the transfer charger wire.
P.206 "Cleaning transfer charger"
Make the density lighter if you use the
manual copy density mode. Or use the
automatic copy density mode.
199