Toshiba e-STUDIO195 Operator's Manual page 202

6 TROUBLESHOOTING
Phenomenon
The copied image is stained.
The copy image is fogged.
The density level of the copy
image is uneven in a horizon-
tal direction.
The copy image is partially
missing.
200 Before Calling Service Technician
Usual cause
The Reversing Automatic
Document Feeder (optional)
/ Automatic Document
Feeder (optional) or the
Platen Cover (optional) is not
lowered fully.
The original glass, platen
sheet, scanning area or
guides are dirty.
The copy density is set
darker.
Highly transparent originals
such as OHP films or tracing
paper are used.
There is a slight gap
between the original glass
and the original.
The copy paper is damp.
The transfer charger wire is
dirty.
The size or direction of the
copy paper and the original,
or the reproduction ratio is
not set properly.
The margin for binding is too
wide.
Countermeasure
Lower them fully to block outside light.
Clean them.
P.204 "Daily Inspection"
Make the density lighter if you use the
manual copy density mode. Or use the
automatic copy density mode.
Place a blank sheet of paper, the same
size as the original or larger, over the orig-
inal.
Lower the Platen Cover (optional) or the
Reversing Automatic Document Feeder
(optional) / Automatic Document Feeder
(optional) fully so that the original will con-
tact with the original glass.
Replace with dry copy paper.
Clean the transfer charger wire.
P.206 "Cleaning transfer charger"
Use copy paper of the same size as the
original or set the reproduction ratio suit-
able to the copy paper size.
Adjust the image shift value again.
P.88 "Shifting Paper to Make Margin -
IMAGE SHIFT -"