The Use Of Relative Value Mode; Max Min Mode - UNI-T UT60H Operating Manual

Model UT60H: OPERATING MANUAL

The Use of Relative Value Mode

The REL mode subtracts a stored value from the present
measurement value and displays the result.
For instance, if the stored value is 20.0V and the present
measurement value is 22.0V, the reading would be 2.0V.
If a new measurement value is equal to the stored value
then display 0.0V.
To enter or exit REL mode:
l Press REL
off, and the present measurement range is locked
and display the present measurement value as the
stored value. The present measurement value
obtained later on is the difference of the stored value.
l Press REL
displayed on the LCD.
l Press REL
above sequence.
l Press REL
mode. The Meter back to the Auto or Manual ranging
measurement mode before entering REL mode.

MAX MIN Mode

To enter or exit MAX MIN Mode, follow the following
procedures:
1. Press MAX MIN to start recording of maximum and
minimum values. Steps the display through the
sequence of high(MAX) and low(MIN) readings
2. Press MAX MIN for more than 1 second to exit Max
Min Mode.
to enter REL mode, auto ranging turns
again to display the REL value,
again to step the display through the
for more than 1 second to exit REL
30
is