Chapter 2 Installation; Requirements; Procedure - TRENDnet TEW-435BRM User Manual

Introduction
Rear Panel
Figure 3: Rear Panel
Reset Button This button will reset the TEW-435BRM to the factory default
(Reset to Defaults) settings.
To do this, press and hold the Reset Button for five (5) seconds, until
the Status LED is lit, then release the Reset Button, and wait the
TEW-435BRM to restart using the factory default values.
Connect the supplied power adapter here.
Power port
Press IN for power ON, OUT for power OFF.
Power switch
Use standard LAN cables (RJ45 connectors) to connect your PCs to
10/100BaseT
LAN connections these ports.
Note:
Any LAN port on the TEW-435BRM will automatically function as
an "Uplink" port when required. Just connect any port to a normal
port on the other hub, using a standard LAN cable.
WAN port Connect this port to your ADSL line.
(ADSL port)
Chapter 2
Installation

Requirements

•
Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.
•
TCP/IP protocol must be installed on all PCs.
•
For Internet Access, an Internet Access account with an ISP, and a DSL connection.
•
To use the Wireless Access Point, all Wireless devices must be compliant with the IEEE
802.11g or IEEE 802.11b specifications.

Procedure

1. Choose an Installation Site
Select a suitable place on the network to install the TEW-435BRM.
5
This Chapter covers the physical installation of the TEW-435BRM.
Figure 4: Installation Diagram
For best Wireless reception and performance, the TEW-
435BRM should be positioned in a central location with
minimum obstructions between the TEW-435BRM and the
PCs.
Also, if using multiple Access Points, adjacent Access
Points should use different Channels.
2
6