TRENDnet TEG-S2400i User Manual page 22

NOTE: Make sure of "Max bridge transit delay bound control" is enabled before enable Delay Bound,
because Enable Delay Bound must be work under "Max bridge transit delay bound control is enabled"
situation.
Broadcast Storm Filter: To configure broadcast storm control, enable it and set the upper threshold for
individual ports. The threshold is the percentage of the port's total bandwidth used by broadcast traffic.
When broadcast traffic for a port rises above the threshold you set, broadcast storm control becomes
active. The valid threshold value is 5%, 10%, 15%, 20%, 25% and off.
Priority Queue Service settings:
First Come, First Serve: The sequence of packets sent is depending on arrive orders.
All High before Low: The high priority packets sent before low priority packets.
WRR: Weighted Round Robin. Select the preference given to packets in the switch's high-priority
queue. These options represent the number of high priority packets sent before one low
priority packet is sent. For example, 5 High 2 Low means that the switch sends 5 high-priority
packets before sending 2 low- priority packets.
Enable Delay Bound: Limit the low priority packets queuing time in switch. Default Max Delay
Qos Policy: High Priority Levels: 0~7 priority level can map to high or low queue.
Time is 255ms. If the low priority packet stays in switch exceed Max Delay
Time, it will be sent. The valid range is 1-255ms.
- 22 -