IP Phone Release Notes 2.3
New Features in Release 2.3
Configuring the Action URI Disconnect Feature Using the Aastra Web UI
Use the following procedure to configure the Action URI Disconnect feature.
Aastra Web UI
1
Click on Advanced Settings->Action URI->Event.
2
In the "Disconnected" field, enter a valid URI for which the phone executes a GET on, when it transitions from
the incoming, outgoing, calling, or connected state into the idle state. Leaving this field empty disables the Action
URI Disconnected feature. For example,
http://fargo.ana.aastra.com/disconnected.xml?state=$$LINESTATE$$
The following table lists the applicable values and descriptions for the $$LINESTATE$$.
$$LINESTATE$$ Value
IDLE
DIALING
CALLING
OUTGOING
INCOMING
CONNECTED
CLEARING
3
Click
48
Description
Phone is idle.
Phone is offhook and ready to
dial.
A SIP INVITE was sent but no
response was received.
Remote party is ringing.
Local phone is ringing.
Parties are talking.
Call was released but not
acknowledged.
to save your settings.
Meaning in a Disconnected URI
N/A
N/A
Error occurred during the call.
Call was cancelled.
Call was missed or cancelled.
Call was successful.
N/A
RN-001029-02, Release 2.3, Rev 00