Operating Speeds; Slide "On/Off" Switch; High Performance Motor; Electronic Monitoring - Dremel 8200 Operating/Safety Instructions Manual

DM 2610007240 08-09:DM 2610007240 08-09 8/21/09 1:11 PM Page 11
For best control in close work, grip the
Rotary Tool like a pencil between your
thumb and forefinger.
WARNING
Wear Eye Protection
To select the right speed for each job, use a
practice piece of material.

SLIDE "ON/OFF" SWITCH

The tool is switched "ON" by the slide switch
located on the topside of the motor housing.
TO TURN THE TOOL "ON", slide the switch
button forward.
TO TURN THE TOOL "OFF", slide the switch
button backward.

HIGH PERFORMANCE MOTOR

Your tool is equipped with a high performance
rotary tool motor. This motor expands the
versatility of the rotary tool by driving additional
attachments such as the Dremel Multi-Saw
and Dremel Planer.

ELECTRONIC MONITORING

Your tool is equipped with an internal electronic
monitoring system that provides a "soft start",
Whenever you hold the tool, be careful not to
cover the air vents with your hand. This blocks the
air flow and causes the motor to overheat.

Operating Speeds

11
The "Golf Grip" method of holding the
tool is used for more aggressive
operations such as grinding a flat surface
or using cutoff wheels.
which will reduce the stresses that occur from
a high torque start. The system also helps to
maximize motor and battery performance by
cutting the voltage to the tool when stall
conditions (see pg. 13) occur. The motor and
battery pack are protected by cutting back the
voltage to the motor in these situations.
VARIABLE SPEED SLIDE SWITCH
Your tool is equipped with a variable speed
slide switch. The speed may be adjusted
during operation by sliding the switch back or
forth between any one of the settings.
You can refer to the charts on page 20, 21,
22 and 23 to determine the proper speed,
based on the material being worked and
the type of accessory being used. These
charts enable you to select both the
correct accessory and the optimum speed
at a glance.