Bissell Quickwash BS-1950F Troubleshooting Manual page 5

Solution 3:
The head of the screw should stick out a ½ inch from the outside of the raised screw hole.
**Older units (units made prior to date code J01111) were made without the raised screw
hole. If this is the case, the screw should not be protruding past the back surface of the unit.
Is the handle screwed in correctly?
Yes, proceed to solution 4
repared by Monique Lania
P
1950F.doc
Make sure the handle screw is in correctly.
Slide handle assembly (with quick release cord wrap)
down into lower body until it will go no further.
**NOTE: It does require a lot of force to get it in
correctly
Secure by placing one Phillips head screw (supplied) into back of
handle assembly. Tighten with Phillips head screw driver until secure
No, proceed to solution 4
How?
No, detach and reassemble handle
Turn unit on, does unit spray now?
5 Call Servicing Guide QuickWash
How?
Yes, problem solved