Becker MAP PILOT Operating Manual page 26

>>> NAVIGATION MODE
Showing the destination on the map
> In the address input menu, push the ro-
> EN
tary control/push button to the right.
> Select
On map
The map display is opened and the desti-
nation is displayed.
Storing a destination
> In the address input menu, push the ro-
tary control/push button to the right.
> Select .
Save
> Enter the desired name.
The destination is transferred to the last
destinations and protected.
25
Starting route guidance
> In the address input menu, select
.
All data entered so far will be processed
during route calculation.
Note:
The icons above the address indicate any
filters you may have activated (e. g.
unpaved roads, toll roads).
If no navigation is active yet and the
function for alternate route selection is
switched on, See "Route options" on
page 45. you can have alternate routes
calculated in the next menu.
to start route guidance.
guidance
Start
> Select alternate routes for the
alternative routes
the displayed routes.
or
> Select
to select the displayed
Use route:
route.
The map display appears and the
navigation begins.
If navigation is already running, you can-
not select alternate routes. You will be
asked whether the new destination should
replace the original destination or whether
it should be used as a stopover.
> Select
Add as stopover
.
destination
Calculate
. Then select one of
or
Replace old