Baxi MULTIFIT Evacuated Tube Collector Kit Instructions page 23

11.0 Installation of solar collecter
11.5 Fitting the Tubes
1. Open manifold lid by removing front seal strip.
2. Open the tube retaining rubbers on the tube clip and place
the tube in the tube clips on both supports rails (Fig. 31).
3. Slide tube into manifold connection while slightly rotating
tube until washer on bellow sits flush against manifold fitting.
Do not apply force, if any problems check alignment of
support rails to manifold.
4. Insert tube retaining clip to secure tube to manifold (Fig. 32).
5. Gently pull on tube to ensure a secure assembly.
6. Close tube retaining rubber on both support rails. Repeat
steps 2 to 6 for all tubes.
7. Close manifold lid ensuring proper engagement of front seal
strip over whole length and on end caps.
Tube Retaining Clip
Tube Retaining Clip
Fig. 32
Front Seal Strip
Tube Clip
Manifold
Support Rail
Tube
Fig. 31
23
© Baxi Heating UK Ltd 2011