Baxi MULTIFIT Evacuated Tube Collector Kit Instructions page 22

Support Rail
Top Clamp
Support Rail
Support Rail
Bottom Clamp
Fig. 29
Support Rail
Bottom Clamp
Locking Pin for
Support Rail
(Landscape)
Manifold
Clamp
Fig. 30
22 © Baxi Heating UK Ltd 2011
Side Rail
Fig. 28
Manifold
Top Clamp
Mark and Drill hole
for Locking Pin
(Landscape)
Locking Pin
for Manifold
(Landscape)
Manifold
Support Rail
Bottom Clamp
Top Clamp
Mark and Drill hole
for Locking Pin
(Landscape)
11.0 Installation of solar collector
11.4 Sloping Roof Kit (Portrait/Landscape) (cont)
NOTE: All side rails are supplied ready for portrait mounting.
For landscape mounting the locking pins must be fitted (Fig.29).
a) Untighten the top clamp nut and remove.
b) Remove spring washer and flat washer.
c) Fit locking pin.
d) Refit spring washer and nut.
11. Loosen the lower support rail top clamps and slide away
from the support rail bottom clamp.
12. Locate the lower support rail and centralise on the side
rails. Slide the top clamp over the support rail to retain
(Fig. 28).
13. For landscape installations, mark the position for the locking
pin holes on the support rail. Drill holes 3mm diameter in the
correct location. Fit the locking pins and ensure full
engagement into the drilled holes (Fig. 29).
14. Tighten the top clamps fully and check the support rail is
secure.
15. Repeat 11 to 14 for the upper support rail.
16. Loosen the manifold top clamps and slide away from the
manifold bottom clamp (Fig. 30).
17. Locate the manifold and centralise on the side rails and slide
the top clamp over the manifold to retain (Fig. 30).
18. For landscape installations mark position for the locking pin
holes on the manifold. Drill holes 3mm diameter in the correct
location. Fit the locking pins and ensure full engagement into
the drilled holes (Figs. 29 & 30).
19. Tighten the top clamps fully and check the manifold is
secure.