During First Use; Switching On The Appliance And Setting The Temperature - Baumatic BWC600SS Instruction Manual

During first use

IMPORTANT: When you use the wine cabinet for the first time
or restart the appliance after it has been turned off for a long
time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED
display. This is normal and it is due to the length of activation
time. Once the wine cabinet has been running for a few hours
everything will be back to normal.
o When you first switch on the appliance, the compressor will run
continuously until the wine cabinet reaches a cool enough
temperature.
o During this period of time, you should try not to open the door
frequently or place bottles inside of the appliance.
o If the unit is switched off or unplugged, you must allow at least 5
minutes before restarting the appliance or reconnecting it to
your mains supply.

Switching on the appliance and setting the temperature

o To switch the appliance on, press the light control button (1)
and the temperature control button (2) simultaneously for 5
seconds.
o The temperature for each zone will need to be set individually.
The temperature settings for both zones are adjustable within
the range of 5°C - 22°C / 40°F - 71°F.
o The temperature set for the lower zone must always be
the same or higher than that in the upper zone.
o When you press the temperature control button (2) for the first
time, the LED display will show the factory default temperature
setting of 12°C / 54°F for both zones.
o Press the temperature control button (2) again and the left LED
indicator for the upper zone will flash. Use the plus (5) and
minus (6) buttons to set the desired temperature for the upper
zone.
o Press the temperature control button (2) yet again and the right
LED indicator for the lower zone will flash. Use the plus (5) and
minus (6) buttons to set the desired temperature for the lower
zone.
11