Setting The Rinse Aid Level; Filling With Dishwasher Detergent - Baumatic BDW17 Instruction Manual

Setting the rinse aid level

The amount of rinse aid that the dishwasher requires also depends on
the hardness of your water. You should experiment with the rinse aid
setting, until you find a level that gives the best results.
o You should continue to adjust the rinse aid level upwards until
you get no water spots.
o If you get cloudiness or streaking on your dishes, the rinse aid
level is set too high and it is causing foaming during the wash
cycle. Turn the arrow clockwise and lower the setting to the next
number.

Filling with dishwasher detergent

The detergent dispenser must be refilled at the start of each wash
cycle (apart from the Rinse wash program).
o Open the lid that closes over the detergent dispenser and place
the detergent inside of the dispenser.
o The section marked 1 in the diagram is for the main wash cycle
detergent. Only one detergent tablet should be placed in the
dispenser at any one time. If you are using detergent powder or
liquid, you should follow the detergent manufacturer's
recommendations.
o The section marked 2 in the diagram can have separate
detergent placed in it for any wash cycle that has a pre-wash
element to it, however this is optional. This must be a liquid or
powder detergent, not another detergent tablet.
o Shut the detergent dispenser lid and position the clip on the
outer edge, so that it holds the lid shut.
o On the first wash cycle, we would recommend
that the rinse aid level is set to number 2.
o If you get water spots and poor drying
performance, then you should turn the arrow
anticlockwise and increase the setting to the next
number.