At The End Of A Wash Program; The 3 In 1 Wash Program - Baumatic BDW17 Instruction Manual

60 cm fully integrated full height electronic dishwasher
Table of Contents

Advertisement

At the end of a wash program

o The time display will flash for 8 seconds and a buzzer will sound.
o If you have used the delay start mode, the time display will flash
for 8 seconds but the buzzer will not sound.
o Open the door of the appliance.
o Use the ON/OFF button to switch the dishwasher off and unload
the dishwasher.

The 3 in 1 wash program

Make sure that the water softener has been filled with salt
and that the water softener has been set to its lowest
setting.
Make sure that the rinse aid dispenser has been set to an
appropriate level.
THIS WASH PROGRAM MUST BE SELECTED IF YOU ARE USING 3
IN 1 DETERGENT. IF YOU USE ANY OTHER WASH PROGRAM
WITH 3 IN 1 TABLETS, THEN YOU MAY GET POOR WASH
RESULTS.
o Hang the 3 in 1 tablet container on the underneath of the upper
basket, in the position shown on the diagram.
o Check that the 3 in 1 tablet container is not going to foul the
upper spray arm, by rotating the spray arm around slowly. If it
does hit the 3 in 1 tablet container, you should move it.
o Put a 3 in 1 tablet inside the 3 in 1 tablet container. Load the
appliance as normal and select the 3 in 1 wash program.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents