Setting The Rinse Aid Level - Baumatic BDI460SS Instruction Manual

o You should continue to fill with rinse aid until the dispenser is
full. Be careful not to overfill the dispenser, as this could cause
oversudsing when a wash program is selected. Wipe away any
rinse aid excess or spillages with a damp cloth.
o Replace the cap and turn it until it locks into position.
o When the rinse aid required neon (K) lights on the control panel,
then you should follow the "filling with rinse aid" procedure
again.
o IMPORTANT: If you are using 3 in 1 dishwasher tablets then it
may still be necessary to fill the rinse aid dispenser. You should
refer to the instructions given by the rinse aid manufacturer.

Setting the rinse aid level

The amount of rinse aid that the dishwasher requires also depends on
the hardness of your water. You should experiment with the rinse aid
setting, until you find a level that gives the best results.
o The dishwasher will leave the factory with the water softener on
setting "A1".
o The rinse aid level can only be set whilst the LED display is
showing "P0".
o Close the door of the dishwasher, you will hear a mechanical
click when the door of the dishwasher is shut properly.
o Press the ON/OFF key (A) to switch the machine on, the LED
display will light up and show "P0". Immediately press and hold
the delay start key (C) until the LED display is showing "A1".
o To alter the rinse aid setting, use the additional rinse key (D) to
cycle through A0 – A2.
Downloaded from DishWasher-Manual.com Manuals
o Slowly pour in liquid
rinse aid, the rinse aid
dispenser will
approximately 100ml
of rinse aid.
hold
14