Figure 2-3. Removing The Hard Disk Drive; Figure 2-4. Installing A Hard Drive In The Cover - HP OmniBook 900 Service Manual

3. Open the hard drive door, then pull out the hard drive by its plastic tab.
Screw, M2.5×5mm
4. If you are installing a new hard drive that does not have a cover, you can remove the cover parts
from the old hard drive:
• Remove the two screws from the case, then lift the plastic tab and remove the plastic cover
and metal shield from the hard disk drive.
• Carefully pry the connector off the end of the hard disk drive. Work alternately at each end so
that the connector slides off evenly.
Screw, M3×4mm
Reassembly Notes
Caution
Do not cover the vent hole in the top surface of the hard drive or in the case. If you cover the hole,
the hard drive could fail prematurely.
• The small plastic tabs on the connector face the top of the drive, and the metal shield fits behind
the tabs.
2-6 Removal and Replacement

Figure 2-3. Removing the Hard Disk Drive

Figure 2-4. Installing a Hard Drive in the Cover

HDD cover kit
Hard disk drive
HP OmniBook 900