Installing a Hard Disk Drive
This section describes how to
♦
♦
♦
To replace the hard disk drive
You'll need a small Phillips screwdriver for this procedure.
1. Unplug the ac adapter, if present, and remove the battery.
2. Turn the unit bottom side up.
3. Remove the hard drive screw from the bottom case.
4. Pull out the hard drive by its plastic tab.
If you are installing a new hard disk drive, you should create a Hibernate partition on
Important
the drive before loading any software—see page 1-84 for instructions.
Replace the hard disk drive.
Replace the hard disk drive holder.
Create a hibernate partition for a new hard disk drive.
Expanding the OmniBook
Installing a Hard Disk Drive
1-81