Rs/6000 Hardware Configuration - Equinox Systems MEGAPORT Hardware Reference Manual

5. After running the automatic configuration, the system
CMOS now contains the configuration of all the adapters
including the MEGAPORT/2. At this point, backup the new
configuration by selecting option 3, Backup configura-
tion, from the set configuration menu.
6. The new configuration is copied onto the Backup Reference
diskette. After the backup is complete, remove the Backup
Reference diskette and store it and the original Reference
Disk in a safe place. Exit the POS configuration utilities
and reboot the system from the hard disk. The system
should boot normally and not display the 165 error message.
The system is now ready to have the device driver installed
as described in the appropriate Software Reference Manual.

RS/6000 Hardware Configuration

MEGAPORT/RS only.
After installing MEGAPORT/RS board, the board must be configured
using the IBM SMIT facility. Refer to the AIX-3 Software Reference
Manual, Equinox part number 560049.
Installing MEGAPORT Boards 17