Release Notes MEGAPORT / MEGAPLEX UNIX System V Release 4 STREAMS Device Drivers (Release 2.24) ISA/EISA Architecture For use with SCO UnixWare, AT&T UNIX, and other SVR4 derivatives READ THIS FIRST PN 560042/K August 1997 MEGAPORT / MEGAPLEX Streams Release Notes 2.24...
NOTE: If you are using UNIX 3.2 you should use the standard Equinox MEGAPORT UNIX driver. If you are using SCO XENIX, you should use the Equinox XENIX driver diskette. Upgrading From Previous Releases of Device Driver MEGAPORT/MEGAPLEX Streams Device Driver Version 2.X represents a major...
# pkgrm eqx The following package is currently installed: eqx Equinox Megaport/Megaplex STREAMS Device Driver (ISA/EISA) (i.386) 2.xx Do you want to remove this package [y,n,?,q] Once you have successfully completed at least one of the removal procedures dis- cussed above, you are ready to proceed with driver installation.
-ixon). Use megastty with the +ixon flag to ignore -ixon on a port. Example: When logged into a MEGAPORT port, enter the following cause the driver to honor XON/XOFF flow control independent of whether the port is set up for -ixon, enter:...
2.10. Corrected initialization "board not found [ECH]" message. Release 2.10 Added flag to utility, megastty +ixon Added support for MEGAPORT XP Fixed problem with eqxlpsetup utility for transparent print. Release 2.02 Added diagnostics utility, megadiag, to release disk Fixed problem that allowed erroneous flow control character initialization Release 2.00...
Added support for MEGAPLEX Increased support to 240 ports Corrected an intermittent condition which caused a panic when the cable was disconnected Changed initialization to start RTS at "off" Release 1.0.1c Initial release MEGAPORT / MEGAPLEX Streams Release Notes 2.24...
Page 8
Equinox Systems Inc. One Equinox Way Sunrise, Florida 33351 support@equinox.com TEL: 954-746-9000 ftp.equinox.com FAX: 954-746-9101 www.equinox.com BBS: 954-746-0282...