Installing Megaport Boards; The Megaport Board - Equinox Systems MEGAPORT Hardware Reference Manual

Chapter 2

Installing MEGAPORT Boards

This chapter describes how to install MEGAPORT, MEGAPORT/2
and MEGAPORT/RS boards into a computer system. The following
topics are covered:

The MEGAPORT Board

EISA Installations
Intermixing MEGAPLEX and MEGAPORT Boards
Installing a Single MEGAPORT Board
Installing Multiple MEGAPORT Boards
PS/2 Type Hardware Configuration
RS/6000 Hardware Configuration
Installing the Round Cable
The MEGAPORT Board
Figure 2-1 is an illustration of the MEGAPORT boards. No hardware
configuration is required on the board. However, make careful note of
the J2 and J3 connector locations. J2 is the input connector and J3 is
the output connector. These connectors are used when more than one
MEGAPORT board is installed. Interconnections between boards are
not required when installing multiple MEGAPORT/2 or
MEGAPORT/RS boards.
MEGAPORT
Figure 2-1. MEGAPORT, MEGAPORT/2 and MEGAPORT/RS boards
Installing MEGAPORT Boards
MEGAPORT/2 and
MEGAPORT/RS
9