Equipment Checklist - Equinox Systems MEGAPORT Hardware Reference Manual

Chapter 3 - Connecting Devices to CS and FM Ports
Chapter 3 describes the procedures used to connect devices to
MEGAPORT CS boards (12CS, 24CS and the second 12 ports
on the 12LD+12CS) and MEGAPORT 12FM boards. Included
are wiring diagrams for assistance in building adaptors and
cables.
Chapter 4 - Connecting Devices to LD Ports
This chapter describes the procedures used to connect devices
to MEGAPORT LD boards (12LD, 24LD and the first 12 ports
on the 12LD+12CS). Included are wiring diagrams for assis-
tance in building adaptors and cables.

Equipment Checklist

A MEGAPORT package contains:
MEGAPORT* Board
Installs in any 80286-, 80386- or 80486-based computer.
1" Interconnect cable (MEGAPORT only)
Used to connect multiple MEGAPORT boards together.
EISA Jumper (MEGAPORT only)
For EISA bus computers.
UNIX/XENIX Device Driver Kit
Provides the software and manual required for installing
MEGAPORT boards in systems running the UNIX System
V 3.2/386 operating system, the 286 or 386 SCO XENIX
operating system and compatible variants.
UNIX STREAMS Device Driver Kit
Provides the software and manual required for installing
MEGAPORT boards in systems running the UNIX System
V Release 4 STREAMS operating system and compatible
variants.
AIX-2 Device Driver Kit (MEGAPORT/2 only)
Provides the software and manual required for
installing MEGAPORT/2 boards in systems running IBM
AIX Version 2.
AIX-3 Device Driver Kit (MEGAPORT/RS only)
Provides the software and manual required for installing
MEGAPORT/RS boards in systems running IBM AIX
Version 3.
Introduction 5