Table of Contents
Advertisement
To access the Security Configuration screen:
1.
Press Print Screen then F2 to access the Advanced Menus screen.
2.
Highlight Setup - Security and press Enter. The Security screen appears.
Figure 3.7: Security Screen
Security Configuration Settings
Setting
Action
Password
Enter current password to activate other fields.
New Password
Type a new password.
Repeat New
Retype new password to confirm it.
Time Delay
Before the screen saver starts, set a value from 1 to 254 minutes or select Off. If
Time Delay is set to Off, the screen saver mode is disabled.
Mode
Energy: Use only with Energy Star-compliant monitors that go into
lower-power mode when Time Delay has elapsed.
Screen: Use with non-Energy Star-compliant monitors.
Test
Immediately activates screen-selected mode.
To set or change the user station password:
1.
On the Advanced Menus screen, highlight the Setup - Security and press
Enter. The Security Configuration screen appears.
2.
If a password already exists, you must first type the current password.
NOTE: The default password is 0123456OSCAR. Because the Caps Lock key is disabled by
default, you must hold down the Shift key as you type each upper case letter. Passwords can be up to
12 characters long and are not case sensitive. Legal characters are: A-Z, a-z, Ø-9 and (space).
3.
Type the new password in the New Password line and press Enter.
4.
Repeat the password in the Repeat New box and press Enter. The word
Changed will appear in the Repeat New box. However, your password is
not activated until you press Enter in either the Time Delay, Mode or Test
fields even if you are not altering those settings.
5.
Highlight Time Delay and use the Plus ( + ) or Minus ( – ) keys to select
the number of minutes, from 1 to 254, before you want your screen saver
Chapter 3: Basic Operations
27
Advertisement
Table of Contents
