Table of Contents
Advertisement
8.
Power up the servers attached to the secondary switch.
9.
If a secondary switch was previously used as a primary switch, reset
OSCAR settings by doing the following:
a.
At the primary switch, press Print Screen to open the OSCAR Selec-
tion screen. Select the port number of the secondary switch.
b.
Press Print Screen again to gain access to the OSCAR Selection
screen on the secondary switch.
c.
Highlight Setup - Devices and press Enter. Press F10 to restore the
default settings, then press Enter.
d.
From the Advanced Menus screen, highlight Names and press Enter.
Press F10 to restore the default settings, then press Enter.
e.
From the Advanced Menus screen highlight Flag and press Enter.
Press F10 to restore the default settings, then press Enter.
f.
Press Escape to exit OSCAR at the secondary switch.
10. At the primary switch, check the status symbols of the servers in the
OSCAR Selection screen. If symbols are different from what is expected,
see the Status Symbols section in Appendix D. Check mouse and keyboard
functions and video signals for each computer.
11. Perform the Snapshot procedure at the primary switch to save mouse and
keyboard settings:
a.
Press Print Screen to open the OSCAR Selection screen.
b.
Highlight Commands - Snapshot and press Enter.
c.
Press Escape to exit OSCAR from the primary switch.
12. Perform the Snapshot procedure at the secondary switch to save keyboard
and mouse settings:
a.
Press Print Screen to open the OSCAR Selection screen then select
the port number of the secondary switch.
b.
Press Print Screen again to gain access to OSCAR at the secondary switch.
c.
Highlight Commands - Snapshot.
d.
Press Escape to exit OSCAR from the secondary switch.
13. Turn off Delay Time at the secondary switch (this prevents OSCAR from
displaying at the secondary switch when selecting servers):
a.
Press Print Screen to open the OSCAR Selection screen, then select
the port number of the secondary switch.
b.
Press Print Screen again to gain access to OSCAR at the secondary switch.
c.
Highlight Setup - OSCAR and press Enter.
d.
Type Ø for Delay Time, then press Enter.
14. If all of the primary switches in the system show the correct port and
server configuration and your mouse, keyboard and video function
properly, your OutLook switch system is ready for operation.
Chapter 2: Installation
15
Advertisement
Table of Contents
