Related Manuals for AudioSource AMP200
Summary of Contents for AudioSource AMP200
- Page 1 OWNER’S MANUAL Phoenix Gold International, Inc. 9300 North Decatur Street Portland, Oregon 97203 Tel: 503.286.9300 Fax: 503.978.3381 Tech Support: 800.950.1449 Web: www.phoenixgold.com Email: support@phoenixgold.com 8100.0303...
-
Page 2: Important Safety Instructions
WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. TO PREVENT ELECTRICAL SHOCK, MATCH WIDE BLADE PLUG TO WIDE SLOT, FULLY INSERT. - Page 3 DC input. There is a switch located on the lower edge of the rear panel of the amplifier to select how you would like to turn on the AMP200. If you would like to control You should use a 3.5mm phone plug in the “IN” connector to the unit’s power on / power off status manually from the front,...
- Page 4 The AMP200 also provides a pair of speaker level inputs for those applications where either of the sources has only speaker level output signal available. This input may be switched to be used in place of the Line 1 or Line 2 input.
-
Page 5: Limited Warranty
AC Power Consumption: 700W (all channels driven) Net Weight: 24.3 lbs (11.0 kgs) Gross Weight: 32.2 lbs (14.6.0 kgs) It should be noted that the AMP200 is rated to operate into a minimum 8-ohm bridged load. AC Mains Fuse: Therefore, if you are using more than a single 8-ohm 115V ~ 60Hz T6.3AL, 250V... - Page 6 Line 2 input. In this circumstance the audio “SPEAKER A” observing proper polarity (see “Speaker Termi- output of the local source will be heard via the AMP200. Once nals” Page 5). Connect a second (optional) pair of speakers to the local source is turned off or muted, the AMP200 will the terminals marked “SPEAKER B”...
Need help?
Do you have a question about the AMP200 and is the answer not in the manual?
Questions and answers