AudioSource Amp Two Owner's Manual

Stereo Power Amplifier with Internal Bridging
Congratulations on your new purchase and welcome to the AudioSource family of satisfied customers.
We trust you will continue to enjoy the value and quality of your AudioSource AMP Two for many years to
come. To ensure the best performance from your unit, please take a few moments to read this manual. Also,
be sure to retain this document for future reference.
Note: If any part of this product is damaged or missing, do not contact your AudioSource dealer. Please call us directly at 800-435-7115.

Using the Controls

Power

This front panel button switches the AMP Two on or off. A multicolored LED indicates its power status.
To use the Auto On feature, leave this front panel switch in the on position.

Speaker Selector

The AMP Two has two pairs of speaker outputs. Press button A to activate the A outputs. Press button B to
activate the B outputs. Both A and B outputs may be used simultaneously, provided the combined impedance
does not fall below 2 ohms.
Note: Before pressing either of the speaker selector buttons, be sure the AMP Two's level controls are set at the minimum position.

Phones

You can connect headphones to the AMP Two using a standard
speakers while you listen through headphones, simply turn off the A and B speaker selector buttons.

Meter X0.1

This switch increases the sensitivity of the meters by a factor of ten, which is useful for monitoring the
AMP Two's output at low volume. In other words, the meters will display ten times the actual power output
when this feature is active. A red LED in this switch indicates activation.

Peak Limiter

The peak limiter modulates high frequencies at high volume, protecting your speakers from damage or
distortion. A red LED also indicates activation of this feature.
AMP Two
Owner's Manual
1 ⁄ " stereo phone jack. To deactivate the
4
© 1999 AudioSource, Inc.