Specifications; Optional System Accessories - Audio Technica 200 Series Installation And Operation Manual

200 series professional vhf wireless systems
Hide thumbs Also See for 200 Series:
Table of Contents

Advertisement

OVERALL SYSTEM
Operating Frequency
Frequency Stability
Modulation Mode
Maximum Deviation
Operating Range
Operating Temperature Range
Frequency Response
RECEIVER
Receiving System
Image Rejection
Signal-to-noise Ratio
Total Harmonic Distortion
Sensitivity
Audio Output
Output Connector
Power Supply
Dimensions
Net Weight
Accessories Included
WIRELESS ESSENTIALS
MICROPHONES AND CABLES
®
All Wireless Essentials accessories are terminated for use with ATW-T201 and
other UniPak
transmitters.
AT829cW
Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen.
MT830cW
Miniature omnidirectional condenser lavalier
microphone. Includes clothing clip and windscreen.
MT830cW-TH
"Theater" model, same as MT830cW except beige colour
mic and cable.
AT831cW
Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen.
AT889cW
Headworn noise-canceling condenser microphone.
Includes windscreen and cable clip.
AT892cW
MicroSet
®
headworn omnidirectional condenser microphone.
Includes element covers, windscreens, moisture guard and
clothing clip.
AT892cW-TH
"Theater" model, same as AT892cW except beige colour
mic, earset and cable.
AT898cW
Subminiature cardioid condenser lavalier microphone.
Includes clothing clip base, viper clip base, magnet clip base,
three single mic holders, two double mic holders and
two windscreens.
AT899cW
Subminiature omnidirectional condenser lavalier microphone.
Includes AT899AK accessory kit.
AT899cW-TH
"Theater" model, same as AT899cW except beige colour mic
and cable. Includes AT899AK-TH accessory kit.
ATM35cW
Cardioid condenser instrument microphone.
Includes AT8418 clip-on instrument mount.
ATM73cW
Headworn cardioid condenser microphone.
Includes windscreen.
ATM75cW
Headworn cardioid condenser microphone.
Includes windscreen.
PRO 8HEcW
Headworn hypercardioid dynamic microphone.
Includes windscreen and cable clip.
PRO 35xcW
Cardioid condenser instrument microphone.
VHF high band, 173 MHz to 175 MHz
±0.005%
FM
±15 kHz
70m typical
40° F (4° C) to 110° F (43° C)
80 Hz to 13 kHz
Non-diversity, single-channel,
dual antenna system
50 dB minimum
80 dB at 10 kHz deviation (IEC-weighted),
maximum modulation 15 kHz
≤1% (10 kHz deviation at 1 kHz)
20 dBµV for 60 dB S/N (IEC-weighted)
350 mV (1 kHz modulation, 10 kHz
deviation, 100k ohm load)
1
/
" TS ("mono") phone jack
4
230V AC (50Hz) to 12V DC 500mA
(centre positive) external power supply.
190.0 mm W x 42.0 mmH x
130.0 mm D
311 grams
Power supply

Optional System Accessories

Specifications

UNIPAK
TRANSMITTER
RF Power Output
Spurious Emissions
Dynamic Range
Input Connections
Battery (not included)
Current Consumption
Battery Life
Dimensions
Net Weight (without battery)
HANDHELD TRANSMITTER
RF Power Output
Spurious Emissions
Dynamic Range
Microphone Element
Battery (not included)
Current Consumption
Battery Life
Dimensions
Net Weight (without battery)
Accessory Included
In the interest of standards development, A.T.U.S. offers full details on its test methods to
other industry professionals on request.
U851cW
U857ALcW
AT8319
AT8317
OTHER ACCESSORIES
AT8114
AT8390
AT8456a
AT8634
ATW-RMS1
ATW-RCS1
ATW-VP10
High: 10 mW; Low: 2 mW, typical
According to National Regulations
≥90 dB, A-weighted
High impedance, low impedance, bias
9V (NEDA type 1604) alkaline
30 mA typical
Approximately 15 hours (High);
20 hours (Low), depending on battery type
and use pattern
65.0 mm W x 110.0 mm H
x 25.4 mm D
78 grams
High: 10 mW; Low: 2 mW, typical
Under Federal Regulations
≥90 dB, A-weighted
Dynamic unidirectional
9V (NEDA type 1604) alkaline
30 mA typical
Approximately 15 hours (High);
20 hours (Low), depending on battery type
and use pattern
241.3 mm long, 53.3 mm
maximum diameter
360 grams
AT8456a Quiet-Flex
Includes AT8418 clip-on instrument mount.
Surface-mount wide-range hemi-cardioid condenser
microphone.
Gooseneck cardioid microphone. Mounts to
Includes AT8663 A-mount flange, AT8664 A-mount cable
pass-through adapter, AT8153 two-stage windscreen
Hi-Z instrument/guitar cable with
Connecting cable for UniPak transmitter with an XLRF-type
input connector, for Lo-Z microphones with XLRM-type
output terminations.
Foam windscreen for handheld transmitter.
Premium instrument cable with
1
Available in a variety of lengths.
Quiet-Flex
microphone stand clamp for handheld
transmitter,
5
/
"-27 threads.
8
Rack-mount adapter kit mounts one ATW-R250 in a single
19" rack space.
Remote mute switch designed to be installed between a
wireless microphone using an HRS-type connector and its
associated body-pack wireless transmitter. Includes
permanently attached 22" cable and belt clip.
Remote momentary-mute/cough switch designed to be
installed between a wireless microphone using an HRS-type
connector and its associated body-pack wireless transmitter.
Includes permanently attached 22" cable and belt clip.
Vinyl UniPak
pouch with belt clip to hold UniPak transmitter.
stand clamp
5
/
"-27 thread.
8
1
/
" phone plug.
4
/
" to
1
/
" phone plugs.
4
4
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Atw-251Atw-251/gAtw-251/hAtw-251/lAtw-252

Table of Contents