Specifications; Overall System Specifications; Atw-R5220/Atw-R5220Dan; Atw-T5201 - Audio Technica ATW-R5220 User Manual

Uhf wireless systems dual receiver dual receiver with dante output body-pack transmitter handheld transmitter (without capsule) 5000 series
Hide thumbs Also See for ATW-R5220:
Table of Contents

Advertisement

Specifications

Overall system specifications

Operating frequencies
*1
ATW-R5220
Band DG1:
Band DF1:
ATW-T5201/ATW-T5202
Band DE1:
Band EG1:
Band FE2:
Minimum frequency step
Modulation mode
Maximum deviation
Dynamic range
Total harmonic distortion
Operating range
*2
Frequency response
*3
*1 Please note that some frequency bands might not be available in your territory or could come with a limited tuning bandwidth/transmitting power due to local regulations.
*2 Open range environment with no interfering signals.
*3 Frequency response depends on attached microphone element.

ATW-R5220/ATW-R5220DAN

Receiving system
Image rejection
RF sensitivity
Maximum output level
Headphone output connector
Headphone output power
Antenna input
Antenna power
Power supply
Operating temperature range
Dimensions
Weight (without accessories)
Included accessories

ATW-T5201

RF output power
Spurious emissions
Input connection
1
4
2
3
High-pass (low-freq. roll-off)
Batteries
Battery life*
Dimensions
Weight (without batteries)
Operating temperature range
Included accessories
* Depending on battery type, usage and environmental conditions.
Frequency range
470.125 to 699.875 MHz
470.125 to 607.875 MHz, 657.100 to 662.900 MHz
470.125 to 590.000 MHz
580.000 to 699.875 MHz
580.000 to 607.875 MHz, 657.100 to 662.900 MHz
25 kHz
FM
ATW-T5201: ±40 kHz (THD:10%)
ATW-T5202: ±40 kHz (THD:10%)
ATW-T5201 Mic input: 120 dB or higher (A-weighted), typical
ATW-T5201 Inst input: 107 dB or higher (A-weighted), typical
ATW-T5202: 116 dB or higher (A-weighted), typical
1.0 % or less (at 1 kHz, ±17.5 kHz deviation)
100 m (328')
ATW-T5201: 23 Hz to 16,300 Hz
ATW-T5202: 33 Hz to 16,300 Hz
True diversity
80 dB nominal
18 dBuV at 60 dBA S/N ratio (50 ohms termination)
XLR, Balanced, +18 dBV
6.3 mm (1/4") TRS Stereo
180 mW, typical
BNC-type, 50 ohms
12 V DC, 150 mA (combined)
100 to 240 V AC (50/60 Hz)
-5 ºC to +45 ºC (23 º F to 113 ºF)
482.0 mm (18.98") x 361.0 mm (14.21") x 43.0 (1.69") mm (W x D x H)
4.8 kg (169.3 oz)
Rack-mount (large, small), Rack-mount screw set, Flexible UHF antenna x 2, AC adapter (country dependent)
High: 50 mW, Mid: 10 mW, Low: 2 mW (switchable), at 50 ohms
Following federal and national regulations
Four pin locking connector
Pin 1: GND
Pin 3: MIC INPUT
80 Hz, 12 dB/octave
Two 1.5V AA, not included
High: 7 hours, Mid: 9 hoursm Low: 10.5 hours (alkaline)
62 mm (2.44") × 70 mm (2.75") × 17 mm (0.67") (W × D × H)
92 g (3.2 oz)
-5 ºC to +45 ºC (23 º F to 113 ºF)
AT-BG3 Protective Carrying Case
32
Number of frequencies
9,191
5,511+233
4,796
4,796
1,116+223
Pin 2: INST INPUT
Pin 4: DC BIAS +5 V

Advertisement

Table of Contents
loading

This manual is also suitable for:

Atw-t5201Atw-r5220danAtw-t5202

Table of Contents