Transmitter Controls And Functions; Lcd Window; Power/Mute Button; Power On/Off - Audio Technica ARTIST ELITE 4000 Series Installation And Operation Manual

Refer to Figures H through Q for an overview of transmitter
functions and controls.
Touch: A momentary press of the Mode/Set button. It is
used to enter Menu mode, to enter Edit mode, or to Escape
without making any changes to current settings.
Hold: A press and hold (about two seconds) of the Mode/Set
button. It is used to accept a new setting when the receiver
is in Edit mode or to save the current settings to one of the
five user-defined name presets or the internal memory
location ("NAME?").

LCD Window

The Liquid Crystal Display presents a great deal of setup and
operating information clearly and conveniently (Figure H). The
LCD in the transmitters is designed for greatest contrast and best
viewing with the window rotated somewhat away from the
viewer (about 30 degrees), not straight-on, for a more
convenient holding/viewing position.

Power/Mute Button

The transmitters have a combination Power and Mute switch
(Figure J/K). When used in combination with the programmed
choices explained below, the various functions available to the
transmitter user may be tailored to fit personal preferences or
particular situations.
Figure H
BATT MIC
H-1. Normal Operation
* AEW-T1000 only: "INST"
Figure J
LCD Window
Power/Mute
Button
Up/Down
Arrows
Sliding
Control Cover
(3-position)
18

Transmitter Controls and Functions

BATT MUTE MIC
▼
*
H-2. Operation with Mute On
Antenna
Power-on LED
Audio Input Jack
Mounting Clip
Set Button
Battery Door

Power On/Off

To turn the transmitter on, hold the Power/Mute button until the
red power indicator and the LCD window come on (about 1–2
seconds). The operating frequency shows in the window after the
power-up sequence.
To turn the transmitter off, hold the Power/Mute button again,
until the red power indicator and the LCD window are
extinguished (about 1–2 seconds). The LCD window shows
" PWR.OFF " before shutdown.

Mute On/Off

When the transmitter is muted, it produces RF with no audio
signal modulation. When the transmitter is un-muted, it
produces both RF and audio.
To mute the transmitter (cut off the audio, but continue the RF
output), touch the Power/Mute button once . A small " MUTE "
appears in the LCD window, just below the frequency (Figure H-
2).
To un-mute the transmitter (restore the audio), touch the
Power/Mute button once again. The " MUTE " disappears from
the LCD window.
▼
MENU
BATT MIC
H-3. Menu Mode (Frequency)
Figure K
Power/Mute
Button
Antenna
Housing
Flashing
▼
EDIT
BATT MIC
H-4. Edit Mode (Frequency)
LCD
Window
Power-on
LED