Handheld Transmitter Antenna; Unipak Transmitter Mounting Clip; Transmitter Controls And Functions; Lcd Window - Audio Technica 4000 Series Installation And Operation Manual

Handheld Transmitter Antenna

The antenna for the handheld mic/transmitter is in the black, non-
metallic section at the bottom of the unit (see
For best results, hold the mic/transmitter naturally, around
Note:
its painted metal case. Holding or otherwise covering the antenna
housing may reduce operating range.

Transmitter Controls and Functions

Refer to Figures H through Q
functions and controls.
Touch: A momentary press of the Set button.
Hold: A press and hold (about two seconds) of the Set button.

LCD Window

The backlit Liquid Crystal Display presents a great deal of setup and
operating information clearly and conveniently
in the transmitters is designed for greatest contrast and best viewing
with the window rotated somewhat away from the viewer (about
30 degrees), not straight-on, for a more convenient holding/viewing
position.

Power/Mute Button

The transmitters have a combination Power and Mute switch
P/Q ). When used in combination with the programmed choices
explained below, the various functions available to the transmitter
user may be tailored to fit personal preferences or particular
situations.

Power On/Off

To turn the transmitter on, hold the Power/Mute button until the
dual-color Power/Mute LED lights green and the backlit LCD window
comes on (about 1–2 seconds). The operating frequency shows in
the window after the power-up sequence.
To turn the transmitter off, hold the Power/Mute button again,
until the dual-color Power/Mute LED and the LCD window are
extinguished (about 1–2 seconds). The LCD window shows "PWR.
OFF" before shutdown.

Mute On/Off

When the transmitter is muted, it produces RF with no audio signal
modulation. When the transmitter is un-muted, it produces both RF
and audio.
To mute the transmitter (cut off the audio, but continue the RF
output), touch the Power/Mute button once. The Power/Mute LED
turns red, and a small "MUTE" appears in the LCD window, just
below the frequency (Figure N-2
To un-mute the transmitter (restore the audio), touch the Power/
Mute button once again. The Power/Mute LED turns green, and the
"MUTE" disappears from the LCD window.
Figure Q on page 20).
for an overview of transmitter
(Figure N ). The LCD
).
Artist Elite 4000 & 5000 Series Professional UHF Wireless Systems
®

UniPak Transmitter Mounting Clip

The UniPak transmitter's mounting clip may be installed with the
case positioned either "up" or "down," depending upon which
is preferred for the particular application. To turn the clip around,
spring the ends of the clip out of the two holes on the sides of the
transmitter case
direction.
Fig. N
N-1. Normal Operation
* AEW-T1000a only: "INST"
t
(Figure
N-3. Menu Mode (Frequency)
Fig. P
LCD Window
Power/Mute
Button
Up/Down
Arrows
Sliding
Control Cover
(3-position)
(Figure P ) and reinstall it facing in the opposite
*
N-2. Operation with Mute On
Flashing
t
N-4. Edit Mode (Frequency)
Antenna
Power/Mute LED
19
t
Audio Input Jack
Mounting Clip
Set Button
Battery Door