CM0264 User Manual
Port Switching Keys
The Port Switching Keys (
or disabled. The default setting is enabled. To disable, do the following:
1. Invoke HSM (see page 27).
2. Press [X] [Enter].
This procedure is a toggle. Repeat to enable.
Firmware Upgrade Mode
To set the CM0264 to Firmware Upgrade Mode, do the following:
1. Invoke HSM (see page 27).
2. Key in: upgrade
3. Press [Enter]. The orange front panel LEDs flash to indicate Firmware
Upgrade Mode is in effect.
Note: To exit Firmware Upgrade Mode, you must power off the switch.
See The Firmware Upgrade Utility, page 47 for details.
Restore Default Settings
To reset the CM0264 to its default hotkey settings, do the following:
1. Invoke HSM (see page 27).
2. Press [R] [Enter].
All hotkey settings return to the factory default settings.
Video DynaSync
Video DynaSync is ATEN's exclusive technology that eliminates boot-up
display problems and optimizes resolution when switching between ports. To
invoke Video DynaSync, do the following:
1. Invoke HSM (see page 27)
2. Press [D]
Note: When the monitor is disconnected and reconnected, the CM0264
executes Video DynaSync one more time.
30
[Scroll Lock] [Scroll Lock]/[Ctrl] [Ctrl]
) can be enabled