Usb Reset; Hotkey Beeper Control; Disable Port Switching Keys; Firmware Upgrade Mode - ATEN CS1762 User Manual

USB Reset

If the USB loses focus and needs to be reset, do the following:
1. Invoke HSM (see page 20 for details).
2. Press and release [F5].

Hotkey Beeper Control

The Beeper can be hotkey toggled On and Off. To toggle the Beeper, do the
following:
1. Invoke HSM (see page 20
2. Press and release [B].
The Beeper toggles On or Off.

Disable Port Switching Keys

To disable the Port Switching Keys ([Scroll Lock] [Scroll Lock] / [Ctrl] [Ctrl]),
do the
following:
1. Invoke HSM (see page 20 for details).
2. Press [X] [Enter].
Note: This procedure is a toggle. To enable the Port Switching keys repeat
steps 1 and 2.

Firmware Upgrade Mode

To set the CS1762 / CS1764
1. Invoke HSM (see page 20 for details).
2. Key in: upgrade
3. Press [Enter].
The front panel LEDs flash to indicate Firmware Upgrade Mode is in
effect.
Note: To exit Firmware Upgrade Mode, you must power off the switch.
).
to Firmware Upgrade Mode, do the following:
A
Chapter 4. Hotkey Operation
23