Object
Auto Negotiation
Speed Ability '100M Full'
Speed Ability '100M Half" Allow set per port run at 100Mbps half speed mode.
Speed Ability '10M Full'
Speed Ability '10M Half"
Priority –Tagging control
TX Bandwidth control
RX Bandwidth control
Port Priority Mapping
4.4.3.2 Set trunk
This command allows disable or enable trunk function of two ports or four ports from FNSW-1608PS. The trunk function
setting screen in
Figure 4-20
Description
Allow disable or enable Auto negotiation of each port.
Allow set per port run at 100Mbps full speed mode.
Allow set per port run at 10Mbps full speed mode.
Allow set per port run at 10Mbps half speed mode.
Allow disable or remove or insert priority tagging on each port, the available options
are Disable, Remove Tag, Insert Tag.
Allow assign per port transmit bandwidth, the available options are Disable, 128K,
256K, 512K,1M,2M,4M,8M.
Allow assign per port receive bandwidth, the available options are Disable, 128K,
256K, 512K,1M,2M,4M,8M.
Allow assign low queue or high queue on each port.
Table 4-2 Descriptions of the Port Configuration screen Objects
appears
Figure 4-20 Trunk Configuration screen
- 25 -