Sharp AR-C260P Key Operator's Manual page 5

KEY OPERATOR PROGRAM LIST
How to enter numbers
When entry of a number is required in a key operator program, enter each digit as follows.
The display shown below is an example. The display will vary depending on the program.
1 In the number entry screen, press [ ] or
[ ] until the desired digit appears.
9----
[ ] [ ]
8----
[ ] [ ]
7----
[ ] [ ]
6----
[ ] [ ]
5----
[ ] [ ]
4----
[ ] [ ]
3----
[ ] [ ]
2----
[ ] [ ]
1----
[ ] [ ]
0----
[ ] [ ]
-----
4
The blinking "-" will
change to a number
from 0 to 9.
When entering a limit
in the "Account limit"
program, enter "0" for
any upper digits that
you do not need
(entries must be
made for all six digits).
2 When the desired digit appears, press the
[OK] key.
0----
If you are entering the key operator code, the
stored digit will change to " ".
If a digit does not store when the [OK] key is
pressed, the digit may be "-" (this appears after 0
through 9 when you press the [ ] or [ ] key).
Check the display and reselect the correct digit.
If you accidentally enter an incorrect digit, press
the [BACK/C] key to move back. The entered digit
will blnk, allowing you to select a new digit.
3 Repeat steps 1 and 2 until all digits of the
number are entered.
01234
The digit is stored and "-"
in the next digit begins to
blink.
The number of digits to
be entered varies
depending on the type of
number being entered.