Sharp AR-C260P Key Operator's Manual page 13

DESCRIPTION OF PROGRAMS
G Auto clear at job end
This program is used to enhance the security
function by repeating data clearing after each job is
finished. The number of data clear repetitions can
be set from 1 to 7. The factory default setting is 1.
Display "AUTO CLEAR AT JOB END" as
1
indicated in the chart on page 28.
AUTO CLEAR AT JOB
END
Press the [OK] key.
2
SET THE NUMBER
1-7
Press the [ ] or [
3
number of repetitions of auto clear at job end,
and press the [OK] key.
This setting is used to enhance the security function
by repeating the data clear operation. See "About the
number of repetitions setting" below.
NOTE
About the number of repetitions setting
The time required for data clearing increases
when a higher number of repetitions is
selected. Select number of repetition settings
that are suitable for your conditions of use.
12
1
] key to select the desired