Setting The Tv Signal; Selecting The Area Group; Selecting The Video Format - Pioneer AVH-P5250BT Operation Manual

Menu operations
! Change this setting if the display switches
to the rear view camera video by error while
you are driving forward.
! To stop watching the rear view camera
video and return to the source display,
press and hold MENU/ .
! Touch the RearView source icon to display
the rear view camera image while driving.
Touch the source icon again to turn the
rear view camera off. For details, refer to Se-
lecting a source using the touch panel keys
on page 11.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch Camera Polarity on the system
menu to select the appropriate setting.
! Battery – When the polarity of the con-
nected lead is positive while the gear shift
is in REVERSE (R) position
! Ground – When the polarity of the con-
nected lead is negative while the gear shift
is in REVERSE (R) position
! Off – When a rear view camera is not con-
nected to this unit

Selecting the video format

You can switch the video output format of
REAR MONITOR OUTPUT between NTSC and
PAL.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch Video Output Format on the sys-
tem menu to select the video output for-
mat.
NTSC—PAL
Note
You can switch the video output format only for
the source from this unit.

Setting the TV signal

When you connect this unit to a TV tuner, be
sure to adjust the TV signal setting to one that
is suitable for your country.
! As this function is initially set to Auto, the
unit will automatically adjust the TV signal
setting.
However, the screen may turn black or
images may not be displayed properly
when Auto has been selected and the re-
ception is weak. Normally, select the appro-
priate TV signal.
! About your country TV signal, consult with
your nearest Pioneer dealer.
! Only when a Pioneer TV tuner (e.g. GEX-
P5700TVP) is connected to this unit, you
can operate this function.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch TV Signal on the system menu to
select the appropriate TV signal.
Auto—PAL—NTSC—PAL-M—SECAM

Selecting the area group

1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch TV Country Group on the func-
tion menu.
3 Touch c or d until the desired area
group appears.
Country1 (CCIR channel)—Country2 (IN
channel)—Country3 (CHN channel)—
Country4 (U.K. channel)—Country5 (OIRT
channel)—Country6 (AUSTRALIA channel)—
Country7 (SAF channel)
Section
13
67
En