Setting The Rear View Camera; Selecting The Video Format; Setting The Tv Signal - Pioneer AVH-3250BT Operation Manual

Section
13 Menu operations
3 Touch Bluetooth Version Information to
display to the version of the Bluetooth
module of this unit.

Setting the rear view camera

(back up camera)
CAUTION
Pioneer recommends the use of a camera
which outputs mirror-reversed images.
Otherwise, the screen image will appear re-
versed.
This unit features a function that automatically
switches to the rear view camera video (V IN)
when a rear view camera is installed on your
car and the gear shift is moved to the RE-
VERSE (R) position.(For more details, con-
sult your dealer.)
! After you set up the rear view camera set-
ting, move the gear shift to REVERSE (R)
and confirm that the rear view camera
video is shown on the display.
! Change this setting if the display switches
to the rear view camera video by error while
you are driving forward.
! To stop watching the rear view camera
video and return to the source display,
press and hold MUTE.
! Touch the RearView source icon to display
the rear view camera image while driving.
Touch the source icon again to turn the
rear view camera off. For details, refer to Se-
lecting a source using the touch panel keys
on page 11.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch Camera Polarity on the system
menu to select the appropriate setting.
! Battery – When the polarity of the con-
nected lead is positive while the gear shift
is in REVERSE (R) position
66
En
! Ground – When the polarity of the con-
nected lead is negative while the gear shift
is in REVERSE (R) position
! Off – When a rear view camera is not con-
nected to this unit

Selecting the video format

You can switch the video output format of V
OUT between NTSC and PAL.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch Video Output Format on the sys-
tem menu to select the video output for-
mat.
NTSC—PAL
Note
You can switch the video output format only for
the source from this unit.

Setting the TV signal

When you connect this unit to a TV tuner, be
sure to adjust the TV signal setting to one that
is suitable for your country.
! As this function is initially set to Auto, the
unit will automatically adjust the TV signal
setting.
However, the screen may turn black or
images may not be displayed properly
when Auto has been selected and the re-
ception is weak. Normally, select the appro-
priate TV signal.
! About your country TV signal, consult with
your nearest Pioneer dealer.
! Only when a Pioneer TV tuner (e.g. GEX-
P5700TVP) is connected to this unit, you
can operate this function.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.