Understanding Auto Ta And Eq Error Messages - Pioneer AVH-P3150DVD Operation Manual

Appendix
Additional Information
iPod
Message
Error-02-6X/-9X/-DX
Error-02-67
No Songs
Stop

Understanding auto TA and EQ error messages

When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message
Error. Please check MIC.
Error. Please check Front
speaker., Error. Please check
Front-L speaker., Error. Please
check Front-R speaker., Error.
Please check Center speaker.,
Error. Please check Rear
speaker., Error. Please check
Rear-L speaker., Error. Please
check Rear-R speaker., Error.
Please check Subwoofer.
Error. Please check noise.
92
En
Cause
Communication failure
iPod failure
Old version of iPod
No songs
No songs in the current list
Cause
Microphone is not connected.
The microphone cannot pick up the
measuring tone of a speaker.
The surrounding noise level is too
high.
Black plate (92,1)
Action
Disconnect the cable from iPod. Once iPod
main menu is displayed, connect the cable
again.
Reset the iPod.
Disconnect the cable from iPod. Once iPod
main menu is displayed, connect the cable
again.
Reset the iPod.
Update the iPod version.
Transfer the songs to iPod.
Select a list that contains the songs.
Action
Plug the supplied microphone securely into
the jack.
! Confirm that the speakers are connected
correctly.
! Correct the input level setting of the power
amp connected to the speakers.
! Set the microphone correctly.
! Stop your car in a place that is as quiet as
possible, and switch off the engine, air condi-
tioner or heater.
! Set the microphone correctly.
CRB2868-A/N
< >92