Installation - Philips WP3870 User Manual

English
8
6mm
"
1/ 2
- Keep heat sources away from the water purifier to prevent distortion
or breakage.
- This water purifier does not soften water.
- Do not install the water purifier in a place where the temperature
drops below 0°C.
- Do not clean the filter with any type of detergent or hot water, as this
damages the filter.
Before first use
Only connect this water purifier to wall-mounted cold water kitchen
faucets or secondary water outlets. Do not connect this water purifier
to sink-mounted faucets.
Make sure that there are no electric cables or water pipes inside the wall
at the location where you want to mount the water purifier.
Make sure that there is no electric outlet under the water purifier.

installation

1 Close the main water valve before you install the water purifier.
2 Determine the location where you want to mount the water purifier
to the wall. This depends on the location of the water outlet and the
available hose length.
3 Remove the drilling template from the box and use it to mark the
points on the wall where to drill the holes.
- Make sure the two top holes are level.
- The recommended distance between the countertop and the lower
mounting hole of the wall holder is 35cm. If you want to be able to fill
high bottles, i.e. 1.5 or 2 liter soft drink or mineral water bottles, drill
the lower hole at 50cm for your convenience. Also make sure that you
leave a free space of at least 15cm above the upper two mounting
holes of the wall holder when you place the water purifier under a
kitchen cupboard or shelf.
4 Drill the holes with a 6mm drill and put the fixing plugs in the holes.
- The fixing plugs and screws are supplied with the water purifier
Note: In case of a wooden wall, skip this step.
Note: In case of a hollow wall, use special hollow wall fixing plugs (not
supplied).
5 If the water outlet has 1/2" thread, screw the water supply
connector onto the water outlet first. Then attach the adapter ring
and finally screw the original kitchen faucet onto the adapter ring.
Wind Teflon tape round all threaded parts to prevent leakage.
Note: If the water outlet is a secondary water outlet, screw the cap onto the
open end of the adapter ring.