Hardware Installation; What You Will Need; Identify The Connectors And Attach The Cables; Connect The Line Interface - Patton electronics DiamondLink 3201 User Manual

Model 3201 G.SHDSL Integrated Access Device User Guide

Hardware installation

If you are already familiar with Model 3201/3241 Router Modem installation and configuration, this chapter
will enable you to finsh the job quickly. Installation consists of the following:
• Preparing for the installation (see section "What you will need")
• Hooking up cables and verifying that the unit will power up (see section "Identify the connectors and attach
the cables")
• Connecting to a PC and launching a web browser for configuration (see "Web Operation and Configura-
tion" on page 24)
• Changing the IP address (if desired) (see section "Router/Bridge Status LEDs" on page 23)

What you will need

• Model 3201 or 3241 G.SHDSL Router Modem
• External power supply for Model 3201 or 3241 (included)
• Ethernet cable with RJ45 plugs on each end (included)
• PC computer

Identify the connectors and attach the cables

All connectors are on the rear panel of the G.SHDSL Router. The Console port is Red, the Ethernet port is
Green, and the Line is Yellow.

Connect the Line Interface

To function properly, the G.SHDSL Router must be connected using twisted-pair, unconditioned, dry, metal
wire, between 19 (0.9mm) and 26 AWG (0.4mm). Leased circuits that run through signal equalization equip-
ment are not acceptable.
The G.SHDSL Router is equipped with an RJ-45 interface jack (Line), which is a two-wire interface. Observe
the signal/pin relationships on the G.SHDSL Router's Line interface jack. The signal/pin relationship is shown
in Figure 5.
Hardware installation
Figure 5. G.SHDSL Router (RJ-45) twisted pair line interface
1 (no connection)
2 (no connection)
1
2
3 (no connection)
3
4 (2-Wire RING)
4
5
5 (2-Wire TIP)
6
6 (no connection)
7
7 (no connection)
8
8 (no connection)
3 • Quick Start Installation
22