Table of Contents
Advertisement
TABLE OF CONTENTS
Section
1.0 Warranty Information .............................................................2
2.0 General Information...............................................................5
3.0 Configuration .........................................................................6
4.0 Installation ..........................................................................35
4.3 Installing the 2710RC Into the Rack Chassis
5.0 Operation .............................................................................39
Appendix A - Specifications ........................................................44
Appendix B - Cable Recommendations......................................45
Appendix D - T1 Interface Pin Assignments ..............................47
Appendix E - DTE Interface Pin Assignments ............................48
1
Page
1.0 WARRANTY INFORMATION
Thank you for your purchase of this Patton Electronics product.
This product has been thoroughly inspected and tested and is warrant-
ed for One Year parts and labor. If any questions or problems arise
during installation or use of this product, please do not hesitate to con-
tact Patton Electronics Technical Support at (301) 975-1007.
1.1 WARRANTY STATEMENT
Patton Electronics warrants all Model 2710RC Series components
to be free from defects, and will-at our option-repair or replace the
product should it fail within one year from the first date of shipment. This
warranty is limited to defects in workmanship or materials, and does not
cover customer damage, abuse, or unauthorized modification. This prod-
uct contains no serviceable parts; therefore you should not attempt to
modify the unit in any way. If this product fails or does not perform as
warranted, your sole recourse shall be repair or replacement as
described above. Under no condition shall Patton Electronics be liable
for any damages incurred by the use of this product. These damages
include, but are not limited to, the following: lost profits, lost savings and
incidental or consequential damages arising from the use of or inability to
use this product. Patton Electronics specifically disclaims all other war-
ranties, expressed or implied, and the installation or use of this product
shall be deemed an acceptance of these terms. In the event that you
detect intermittent or continuous product malfunction due to nearby high
power transmitting radio frequency equipment, use only data cables with
an external outer shield bonded to a metal or metalized connector.
WARNING!
This device is not intended to be con-
nected to the public telephone network in Europe.
1.2 RADIO AND TV INTERFERENCE
The NetLink-T1™ Model 2710RC Series generates and uses radio
frequency energy, and if not installed and used properly-that is, in
strict accordance with the manufacturer's instructions-may cause
interference to radio and television reception. The Model 2710RC
Series has been tested and found to comply with the limits for a Class
A computing device in accordance with the specifications in Subpart B
of Part 15 of FCC rules, which are designed to provide reasonable pro-
tection from such interference in a commercial installation. However,
there is no guarantee that interference will not occur in a particular
installation. If the Model 2710RC Series causes interference to radio or
television reception, which can be determined by disconnecting the
cables, try to correct the interference by one or more of the following
measures: moving the computing equipment away from the receiver,
re-orienting the receiving antenna, and/or plugging the receiving equip-
ment into a different AC outlet (such that the computing equipment and
receiver are on different branches).
2
Advertisement
Table of Contents
